It's a specialized solution that helps you better measure automotive functional testing.
Major Business
Vehicle Ethernet
Network Analysis
Simulation
Functional Test
Engineering Service
CM CAN COMBO
Art.-Nr. : TE-1171
Capture your CAN(-FD), FlexRay and RS-232 traffic in the car via an Ethernet uplink
Capture your CAN(-FD), FlexRay and RS-232 traffic in the car via an Ethernet uplink
Description
The Capture Module CAN Combo is used to capture the traffic from the conventional CAN busses, as well as CAN-FD, FlexRay and RS-232 can be captured without interfering the original networks.
The messages are timestamped with 40 ns resolution when captured and sent within the PDUs of Ethernet MAC II frames via 100BASE-T1 or Standard Ethernet. Several devices can be used on the same setup, and the in-built-synchronization using 802.1AS allows for simultaneous use with the other “IVN2Eth Capture Modules”.
Features
6x CAN /CAN-FD
1x FlexRay
2x RS-232/TTL
Technically Enhanced Capture Module Protocol (time stamping…)
Configure easily via webserver
Network Time Synchronization (802.1AS) - allows synchronization
Cascading and synchronization of multiple devices
Source Timestamping with 40 ns resolution
High Speed Startup
Startup Buffer
Output Traffic Shaping
Rotary Switch for manual configuration of IP-Addresses (Gbit- RJ-45)
Wakeup capable
Extended Power Mode for Car integration
Robust stainless- steel case
Size: 129 x120 (134) x 32mm
